huangyhg

scaling center, dashed, phantom, and hidden lines in autocad
this may be a very basic question, but what are the accepted standards for drawing center, dashed, phantom, and hidden lines? for dashed and hidden lines, how long should the lines be and what should the gap between the lines be? for center and hidden lines, how long should the long and short lines be and what should the gap between the lines be? what rule of thumb should be used for establishing the linetype scale for these linetypes in autocad? thank you very much for your responses.
check out our whitepaper library.
try posting your question in the autocad forum
look at asme y14.2m-1992 for standard line definitions.
"wildfires are dangerous, hard to control, and economically catastrophic."
ben loosli
sr is technologist
l-3 communications
promoting, selling, recruiting and student posting
are not allowed in the forums.
(add stickiness to your site by linking to this professionally managed technical forum)
title: drafting standards,
description: drafting standards, gd&t & tolerance analysis technical support forum and mutual help system for engineering professionals. selling and recruiting forbidden.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]