yang686526

beta 2.7.0: a dwg crashes pdfexport()
beta 2.7.0: a dwg crashes pdfexport()
library beta 2.7.0
the attached dwg causes an internal error in the pdfexport() function
2.6.1 works fine
regards,
ciro ettorre
attached files
i can reproduce it in 2.7.0.0 but 2.7.0.1 (beta2) works ok.
sergey slezkin
when it will be published ?
it's already available at odoutgoing.
sergey slezkin
hello sergey,
from our tests, the crash is still there
are you sure it has been fixed ?
can you please try again with the dwg i sent in my past email ?
thanks,
ciro
hello sergey,
did you read my previous post ?
ciro
hello,
could you please test your file with mfcapp pdfexport. i cannot reproduce any crashes with your file. so i need some help from you. it will be very helpful, if you reproduce problem with mfcapp and report about pdfexport input flags here. you also can modify some code inside mfcapp and publish changes here.
ps : 2.7.0.1 vc8 dll configuration was tested. i test with file attached to this topic only.
i have double checked the dd_vc8md/lib/* files just now, yes, vc8 libraries can convert the dwg file to pdf file.
however, this problem still exist in the vc6 libraries.
it seems that vc6 libraries haven't been updated yet
ciro
thanks for info... i'll test it in few minutes.
i need some additional information... dwg 2 7 0 1 beta 2 vc6 lib doesn't include mfcapp.exe. could you please describe your test steps? i have found only that odamfcapp.exe from vc6dlldbg folder crashes at loading moment, but release version loaded your file and exported it to pdf without any probems. how i can reproduce pdf export crash with using of libraries\application from dwg 2 7 0 1 beta 2 zips ?
hello,
i have just verified that the crash is fixed with the vc8 libs
i have rebuilt my application with vc8 so everything is fine now - you can close the call
regards,
ciro
thank you.