huangyhg

tolerance calcs
just thought this may be helpful to any of you.
ctopher,
you do realize don't you that the formulae for gd&t positional tolerances are very simple?
for a screw passing through a clearance hole into a tapped hole, the positional tolerances equal one half the diametral clearance, based on mmc values. for a bolt passing through two clearance holes, the positional tolerances equal the diametral clearance, again, based at mmc.
most of the time, i do the arithmetic in my head. without the convient tables, people might consider alternate gd&t schemes like setting the positional tolerance to zero (usually but not always at mmc), using holes as datums.
jhg
yes, i know. thanks drawoh.
the link is just for anyone that does not understand it and want a visual tool. just for info.
chris
sr. mechanical designer, cad
solidworks 05 sp2.0 / pdmworks 05
ctopher,
i also do the math in my head, or scratch it down with other numbers i'm working with, but this is a good tip. the site has alot of good reference information other than gd&t.
it's scary to think that there are people who would use those calculators without understanding what they are doing!
tunalover
i was taught to do it by hand. but, these days i hear the excuses all the time from engineers and designers that they either don't have time (too busy) or why do it if it is available online.
sometimes when i get very frustrated with coworkers, i catch myself doing the same. or sometimes if i'm rushed, i may use the online site for check.
chris
sr. mechanical designer, cad
solidworks 05 sp2.0 / pdmworks 05

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]