huangyhg

asme y14.5-1994 assumed 90 degree angle on the print
under the asme y14.5-1994 - is there anything relating the appearance of all right angles as 90 degrees. i have been told that you must assume that all right angles are 90 degrees.
1. is it true under the asme standard i posted?
2. furthermore, do you assume the title block tolerance on that 90 degree angle??
thanks in advance
eng-tips forums is member supported.
take a look to see if this answers your question
yes, fundamental rule 1.4(i) says this very thing, if you have a standard handy, it's on page 4. a more in-depth explanation is on 2.1.1.2 on page 23.
powerhound
production supervisor
inventor 11
mastercam x2
smartcam 11.1
ssg, u.s. army
taji, iraq oif ii
thanks for the posts!! thats all i needed
promoting, selling, recruiting and student posting
are not allowed in the forums.
(add stickiness to your site by linking to this professionally managed technical forum)
title: drafting standards,
description: drafting standards, gd&t & tolerance analysis technical support forum and mutual help system for engineering professionals. selling and recruiting forbidden.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]