yang686526

setting extrude end condition... help!
i have this section of code i am trying to modify,
set swpartdoc_tm = tubemodel
set swfeat = swpartdoc_tm.featurebyname("e" & endnum & "m" & cutnum & "_miter")
set swfeatdef = swfeat.getdefinition
if cutdata(endnum, cutnum).thrutype = 1 then
swfeatdef.setendcondition true, swendcondthroughnext
swfeatdef.setendcondition false, swendcondthroughnext
else
swfeatdef.setendcondition true, swendcondthroughall
swfeatdef.setendcondition false, swendcondthroughall
end if
stat_b = swfeat.modifydefinition(swfeatdef, tubemodel, nothing)
and instead of the swendcondthroughnext, i want it to be "up to vertex" but not sure how to set that. this is the code that is run if i do a macro record on what i want to do.
set swapp = application.sldworks
set part = swapp.activedoc
set selmgr = part.selectionmanager
boolstatus = part.extension.selectbyid2("e1m1_round", "bodyfeature", 0, 0, 0, false, 0, nothing, 0)
part.clearselection2 true
boolstatus = part.extension.selectbyid2("point1@convergence_pts", "extsketchpoint", -0.2032, 0, 0, true, 1, nothing, 0)
boolstatus = part.extension.selectbyid2("point1@convergence_pts", "extsketchpoint", -0.2032, 0, 0, true, 2, nothing, 0)
part.selectionmanager.enablecontourselection = 0
end sub
again, i don't know how to get it to work correctly. any help would be wonderful!
thanks
you need to change these lines:
swfeatdef.setendcondition true, swendconduptovertex
swfeatdef.setendcondition false, swendconduptovertex
and then set the vertex or entity that defines the up to location like so:
swfeatdef.setendconditionreference true, myvertex
swfeatdef.setendconditionreference false, myvertex
where myvertex is a vertex or sketch point of your choice