huangyhg

structural deign of chute(s)
i am looking for some design example / guidance for the structural deign of different types of chutes in material handling application, for example crusher discharge chute, screen discharge chute and other types of small or large chutes. i tried material handling forum but need more information. if possible, please advise if there is any good book or web site on this subject or any other information. thank you in advance for your assistance.
am

the cross-section of the chute is usually established by the drafter and mechanical engineer based on geometry of the equipment, in your case the crusher discharge and associated transfer conveyor. the depth of the chute is based on the material flow rate. the angle of inclination is usually provided by the mechanical engineer based on material properties, especially moisture content. one paper that may be of interest is 鈥淒esign principles for chutes to handle bulk solids鈥?by d.s. dick and t.a. royal (
dbuzz
thank you very much for this information. i downloaded the article and will go through it now.
i will be looking forward to any other recommendation also on this subject.
regards
am

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]