huangyhg

flitch plate design
when designing a wood/steel section(beam) with flitch plate, is it reasonable to determine a "transformed" allowable bending stress, fb, by reason of propotionality?
i.e.
a 4-ply 2x12 syp #1 (fb=1,062 psi)(wet-service adjusted)
w/1-ply a36 0.25x11 (fb=21,600 psi)
a(syp)=67.5 si
a(a36)=2.75 si
a(combined)=70.25 si
therefore:
fb(syp)=(67.5/70.25)1,062=1,019 psi
fb(a36)=(2.75/70.25)21,600=864 psi
fb(combined)=1,019+864=1,883 psi
please advise... thank you...
check out our whitepaper library.
you do not "transform" stresses. if you transform the steel to wood, use the allowable stress for wood. if you transform the wood to steel, use the allowable stress for steel.
how do you transform one material to the other?
modular ratio = n = e steel / e wood . look into any area or section transformation method in a book or simply type it on internet.
in a nutshell, here is the process:
1. run your analysis in the software of your choice knowing that the wood alone will fail. the analysis will give you the shear(v), moment(m), and deflection(d).
2. decide what wood depth you will use as well as species, which includes lvl.
3. choose an initial steel thickness, starting with 1/4" plate. fy=36 ksi (assume the depth of the steel to be 1/4" less than the outer wood
jopalu, i am shocked that you are asking this question if you are an engineer!!!
you need to go back to your statics and strength!!!
i would suggest that he does all manual calculations. using software is not a good idea since he does not know how to transform one material to another.
sorry if i am being harsh.
regards,
lutfi
i totally agree with lutfi. that is an early junior year or sophomore year skill.
jopalu,
this site has great walk-thru examples of what you are trying to do....explaining each step along the way. specifically, click on "bending" and then "non-homogenous"

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]