huangyhg

base plate for cantilevered pipe column
i've seen threads for cantilevered columns, but all information i have come across such as aisc design guide 1 seems to be specific to wide flange columns. also, i have found an article for pipe column base plates, but it was for gravity loading. is there any sort of guide to design a base plate for a round hollow section that is subjected to moments?
find a job or post a job opening
jeremybraggpe,
take a look at this design manual, it seems very comprehensive to me.
thanks mike.
i couldn't find anything in a general search, but after wading through 33 pages of this forum, i found a similar question. i don't know how i missed it, but there is a small section in the aisc design guide that references how to treat tube and pipe. i will definitely check out the risa reference. thanks again.
page 16 of design guide one states base plates for round or rectangular columns can be designed with the provisions developed for wide flange columns.
is all it's getting is a cantilever load or is it getting axial as well? if it's the former, you'll have to design the base plate for bending and uplift on the back side fastener's as well (depending on how you connect it to your ground or what have you).

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]