huangyhg

included angle
does anyone use the expression "included angle" or "included" on drawings when describing angles?
check out our whitepaper library.
if i am not wrong ..is that the one we call step angle in autocad??..& in other words is it increment angle??? i am not sure....
ug nx5,solid works
included angle would be the total angle of a countersink. i.e. 100deg for use with a 100deg flat head screw. also the angle on the screw could be described as and included angle. i have seen the term used in describing a countersink in a note.
peter stockhausen
senior design analyst (checker)
infotech aerospace services
thank you for your help. there was a half angle on a drawing and it had the note included below it. it was intended to imply the full angle. may of us were not familiar with this term.
thank you for you help.
i have used "included" in several locations.
sometimes just to eliminate potential abiguity, to ensure i got the right angle or taper.
in molded or cast parts, where you have to watch wall thickness build up on drafted surfaces, i always call out the "included" draft angle on free standing features such as bosses and ribs.
promoting, selling, recruiting and student posting
are not allowed in the forums.
(add stickiness to your site by linking to this professionally managed technical forum)
title: drafting standards,
description: drafting standards, gd&t & tolerance analysis technical support forum and mutual help system for engineering professionals. selling and recruiting forbidden.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]