yang686526

block name that uses double-byte characters(japanese kanji c
block name that uses double-byte characters(japanese kanji characters)
i have the problem of the output processing of block name,
layer name, linetype name, textstyle name, and dimstyle name.
it is because such an output result is brought.
( dd changes the value that i set )
[dwg]
block name value == "$ddt_audit_generated_(2d)"
[audit report.txt]
acdbblocktablerecord(2d) non xref-dependent record contains vertical bar. invalid $ddt_audit_generated_(2d)
i investigated the pattern which brings this result.
* if oddbauditinfo is used, it is generated.
( oddbdatabase::auditdatabase(oddbauditinfo*) )
* i did not use xref.
* it used double-byte characters. (i used japanese kanji characters)
the value of lead_byte or trail_byte is 124(0x7c).
(for example, combination of lead_byte and trail_byte "129+124","141+124" etc)
if it is 124 of single-byte characters, that it does not use understands.
( single-byte characters 124(0x7c)=="|" )
however, this case is a part of double-byte characters.
this problem occurs only when it uses oddbauditinfo.
( however, i want to use oddbauditinfo )
if there are any solutions, please let me know.
( i examined it by dd version 1.11 and 1.12 )