yang686526

请顾老师帮忙反编此程序
www.dimcax.com
请顾老师帮忙反编此程序
(defun c:gc()
(setvar "cmdecho" 0)
(setq en (entsel "请选齿顶圆:"))
(setq dxzb(cadr en))
(setq en1 (entsel "\n请选切割图:"))
(setq pts(car en))
(setq yx (osnap dxzb "cen"))
(setq pts1(car en1))

(setq kbjd (getpoint "\n请选拷贝的基点:"))
(setq fdybj (getreal "\n请输入齿轮分圆半径:"))
(setq zxzjd (getreal "\n请输入总圆旋转角度:"))
(setq xzjd (getreal "\n请输入每一步圆旋转角度:"))

(setq kbjl (* (/ (* xzjd 3.14159) 180) fdybj))
(setq zxhcs (fix (/ zxzjd xzjd)))
(setq xhcs 1)
(while (<= xhcs zxhcs)
(setq kbzd (polar kbjd 0 kbjl))
(command "copy" pts1 "" kbjd kbzd)
(setq pts2 (entlast))
(command "subtract" pts "" pts1 "")
(command "rotate" pts "" yx xzjd)
(setq pts1 pts2)
(setq xhcs (1+ xhcs))
)

(prin1)
)
这是个模拟滚齿程序，希望老顾能反编此程序，就是已知工件图，生成刀具图。