yang686526

direct access to explode lines
hi guys,
is there a procedure to directly access explode lines? i know you can first invoke the command to draw them and could, say, use sendkeys to escape or enter to edit mode; but i'm trying to decipher what exactly makes an explode line unselectable without the extra steps. is it on a layer? does it have some special property that makes it visible, but not touchable?
any information would be helpful. have written an app to do some simulations and see that being able to draw a line or spline that is not considered a 3d sketch by sw interface would be useful, and would be consistent with the practices used in programs like floworks.
thanks,
danielle
danielle
quick