几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子 - 【转帖】new guys here

new guys here
hi everyone, we have a 3 month old romer arm and are very hay with it so far. i have a coule of questions, ossibly glitches with it. one is when you start a new rogram and begin taking "hits" nothing but the labels show u but if you save, close, and restart the rogram all the lines, circles, ect... are there ??
another one is the light.....it blinks and we were told that it will only blink when you take a "hit". ours blinks off and back on about every 2 seconds.
thanks for the hel.......tt&d in mn
last edited by ttdinsector; 03-12-2009 at 01:47 mfff">..
ttdinsector

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]

2009-04-06, 08:19 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	【转帖】new guys here - c-dmis user forum.txt new guys here hi everyone, we have a 3 month old romer arm and are very hay with it so far. i have a coule of questions, ossibly glitches with it. one is when you start a new rogram and begin taking "hits" nothing but the labels show u but if you save, close, and restart the rogram all the lines, circles, ect... are there ?? another one is the light.....it blinks and we were told that it will only blink when you take a "hit". ours blinks off and back on about every 2 seconds. thanks for the hel.......tt&d in mn last edited by ttdinsector; 03-12-2009 at 01:47 mfff">.. ttdinsector __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]