huangyhg

wood connections - built up member
i need to design a wood member (either sawn or engineered lumber) that will act as a single unit under load. the section will be built up from pieces fastened face to face and on edge. for instance, if (4) 1 1/2 x 7 1/4 units are to be used in the final section, two will be on the bottom, two on top, so the final section is a 3"x14 1/2" member. how can i calculate a fastening that will ensure these members act as one piece?
try

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]