|
超级版主
注册日期: 04-03
帖子: 18592
精华: 36
现金: 249466 标准币
资产: 1080358888 标准币
|
welding issue
welding issue
a 5/16 in fillet normally does not need two passes. correct? is there a table indicating when more than one pass is needed? sorry, i' am little fuzy on this. thanks for your help.
a 5/16" weld is a general rule of thumb for the largest fillet weld that can be deposited in a single pass - aws d1.1 table 3.7 provides maximum single pass weld sizes for various procedures and positions. see the following modern steel article for a more involved discussion:
__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]
|