几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

screws in light gage steel framing
the nominal screw shear strengths for both aisi and nz code are very close to each other. but in aisi the resistance factor is 0.5, in nz code it is 0.9. the governing vertical load combination is same in both of these codes : 1.2dl+1.6ll. what is the reason for this difference? one of the codes should be either too conservative or unconservative isn't it?
nz : new zealand code
maybe the bearing strength on the usual gages make in appilcation that the screw shear strength don't control, so except in the rare case the thin screws could control, the designs would continue being the same. o r in other words, given the bearing strengths, it is unnecessary to state the shear strength at the attainable values. but this is only conjecture.

2009-09-15, 08:12 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	screws in light gage steel framing screws in light gage steel framing the nominal screw shear strengths for both aisi and nz code are very close to each other. but in aisi the resistance factor is 0.5, in nz code it is 0.9. the governing vertical load combination is same in both of these codes : 1.2dl+1.6ll. what is the reason for this difference? one of the codes should be either too conservative or unconservative isn't it? nz : new zealand code maybe the bearing strength on the usual gages make in appilcation that the screw shear strength don't control, so except in the rare case the thin screws could control, the designs would continue being the same. o r in other words, given the bearing strengths, it is unnecessary to state the shear strength at the attainable values. but this is only conjecture. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]