几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

problem with a guyed stack
we are replacing some equipment stacks and after a number of problems with the existing building steel we are at last down to the guy wire hold downs (deadman).
the existing stack has three single cable tiedowns with a turnbuckle connection to the deadman. the new stack will have three pairs of cables, and of course, coming down to the existing deadman.
the plate and welds on existing work, but the geometry does not.
the existing plate is 1 1/4" thick, 6" across the base and 0'-8" to the center of the existing 1 1/2" dia hole for the turnbuckle.
i am looking for the simplest way to resolve without cutting out and replacing.
any help is appreciated.
jjf

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]

2009-09-15, 02:51 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	problem with a guyed stack problem with a guyed stack we are replacing some equipment stacks and after a number of problems with the existing building steel we are at last down to the guy wire hold downs (deadman). the existing stack has three single cable tiedowns with a turnbuckle connection to the deadman. the new stack will have three pairs of cables, and of course, coming down to the existing deadman. the plate and welds on existing work, but the geometry does not. the existing plate is 1 1/4" thick, 6" across the base and 0'-8" to the center of the existing 1 1/2" dia hole for the turnbuckle. i am looking for the simplest way to resolve without cutting out and replacing. any help is appreciated. jjf __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]