几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

over the ridge drift
i am looking for some input as to whether standard snow drift needs to be applied in combination with over the ridge drift.
the example i am thinking of would have two buildings attached end to end at the gables with one of them being taller than the other. in this scenario it would be possible to have over the ridge drift accumulate on one side of both buildings. then when the wind shifts directions the taller building would drift down onto the lower building increasing the drift load even more.
is this too conservative? i was not able to find anything referring to this situtation in either asce or ibc.
thanks in advance for your input.
~waytsh

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]

2009-09-15, 11:02 AM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	over the ridge drif over the ridge drift i am looking for some input as to whether standard snow drift needs to be applied in combination with over the ridge drift. the example i am thinking of would have two buildings attached end to end at the gables with one of them being taller than the other. in this scenario it would be possible to have over the ridge drift accumulate on one side of both buildings. then when the wind shifts directions the taller building would drift down onto the lower building increasing the drift load even more. is this too conservative? i was not able to find anything referring to this situtation in either asce or ibc. thanks in advance for your input. ~waytsh __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]