huangyhg

masonry horizontal joint reinforcing.
when using a #9 dur-o-wall horizontal joint reinforcing at 16" o.c. what are the requirements for lapping this type of reinforcing at the corners? is the mason supposed to buy a prefabricated corner section to use in these locations or is lapping allowed?
i can't seem to find any requirement in aci 530.1.

check out our whitepaper library.
with the ladder type, i generally lap it 'one rung' <g>. i seem to recall dur-o-wal has a discription of the splicing.
dik
lap ends of reinforcement 6". it is common to cut the interior wire and field bend the continuous reinforcement at corners.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]