几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子 - deformation of flat plate with uniform thickness

deformation of flat plate with uniform thickness
hi
i'm looking for a formula that will yield the maximum stress and deformation of a flat plate under uniform load. i understand from a previous post that pounder's plate theory is the way to go, but i do not have a copy of the text they reference. is it available on the net?
for circular and annular plates you'll find it in the site below (rectangular plates to come...).
prex
thank you. unfortunately i am looking for the rectangular plate formula.
try "roark's formulas for stress & strain" - mcgraw-hill.
two sources that i can think of:
- roark's book chapter 10 table 26
- mark's standard handbook for mechanical engineers 1978 edition page 5-52 & 5-53
if you don't have these resources post you details and i am sure someone will post an answer. rich
i think there is a mathcad 2000 pro sheet downloadable from the collaboratory site. i can send it (plate10b.mcd) to you, of if you can't make it operative, a .doc file to see the formulation at least. post if so an e-mail address.
thanks everyone, i have found a copy of the info and it is exactly what i needed.

2009-09-08, 05:04 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	deformation of flat plate with uniform thickness deformation of flat plate with uniform thickness hi i'm looking for a formula that will yield the maximum stress and deformation of a flat plate under uniform load. i understand from a previous post that pounder's plate theory is the way to go, but i do not have a copy of the text they reference. is it available on the net? for circular and annular plates you'll find it in the site below (rectangular plates to come...). prex thank you. unfortunately i am looking for the rectangular plate formula. try "roark's formulas for stress & strain" - mcgraw-hill. two sources that i can think of: - roark's book chapter 10 table 26 - mark's standard handbook for mechanical engineers 1978 edition page 5-52 & 5-53 if you don't have these resources post you details and i am sure someone will post an answer. rich i think there is a mathcad 2000 pro sheet downloadable from the collaboratory site. i can send it (plate10b.mcd) to you, of if you can't make it operative, a .doc file to see the formulation at least. post if so an e-mail address. thanks everyone, i have found a copy of the info and it is exactly what i needed. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]