几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

bolt direct tensioning
hi all,
when it is specified that a bolt is to be direct tensioned to 70% of capacity, would it mean that i can obtain that direct tension force by multiplying the bolt area by its ultimate strength and then by 0.70, or are there additional factors that i have to take in consideration? a prompt response would be appreciated!
find a job or post a job opening
what are some direct tensioning procedures?
"direct tensioning procedures" sounds like preload (via torque wrench).
there are "standard" tables for preload in "typical" (shear)applications, depending on the size. a rule of thumb is t = p*d/5 (t=torque, p-=preload, d = diameter).
the high value of preload you've quoted (70% fty) is usually applicable to bolts with tension loads applied; in order that the joint doesn't gap inservice.
use the bolt area at the threads. only use high strength bolts, a325 & a490. tension indicators are very reliable, either the washers with bumps or paint and the break off bolt.

2009-09-07, 04:07 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	bolt direct tensioning bolt direct tensioning hi all, when it is specified that a bolt is to be direct tensioned to 70% of capacity, would it mean that i can obtain that direct tension force by multiplying the bolt area by its ultimate strength and then by 0.70, or are there additional factors that i have to take in consideration? a prompt response would be appreciated! find a job or post a job opening what are some direct tensioning procedures? "direct tensioning procedures" sounds like preload (via torque wrench). there are "standard" tables for preload in "typical" (shear)applications, depending on the size. a rule of thumb is t = p*d/5 (t=torque, p-=preload, d = diameter). the high value of preload you've quoted (70% fty) is usually applicable to bolts with tension loads applied; in order that the joint doesn't gap inservice. use the bolt area at the threads. only use high strength bolts, a325 & a490. tension indicators are very reliable, either the washers with bumps or paint and the break off bolt. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]