几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

2 story x brace
when using a 2 story x brace (scbf), is there any need for the upper story to be as strong as the lower story.
if only the lower story had a chevron brace, the 2nd floor beam would need to be designed to take the unbalanced load. when we add an inverted chevron brace on the 2nd floor, then the beam does not need to be designed for the unbalanced load. so, does the same size brace need to be used on both the 1st and 2nd floors? do you have any references to back up your opinion?
i'm using the 2005 aisc seismic spec.
find a job or post a job opening
your bracing
good point, but my unbraced lengths are generally pretty short, 25ft or less. most of my brace designs are governed by load. thanks though.

2009-09-06, 10:52 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	2 story x brace 2 story x brace when using a 2 story x brace (scbf), is there any need for the upper story to be as strong as the lower story. if only the lower story had a chevron brace, the 2nd floor beam would need to be designed to take the unbalanced load. when we add an inverted chevron brace on the 2nd floor, then the beam does not need to be designed for the unbalanced load. so, does the same size brace need to be used on both the 1st and 2nd floors? do you have any references to back up your opinion? i'm using the 2005 aisc seismic spec. find a job or post a job opening your bracing good point, but my unbraced lengths are generally pretty short, 25ft or less. most of my brace designs are governed by load. thanks though. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]