几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子 - ansi 9standards0 code issues

ansi standard drawing views
are there any drawing standards that dictate the aircraft orientation in drawing views("top", "front" "left" views)? as for me, a "top view" would always be looking down at the top of the aircraft, with forward to the left. a "front view" would be looking at the left side of the aircraft. a "left view" would be a looking aft from the front of the plane. a "right view" would be looking forward from the aft of the plane.
this may be a posting for drafting standards forum:
in the uk there was a def stan (5-10 or 05-123 maybe) that defined that the front or nose of the aircraft (or aircraft store) was to the left of the drawings. i had to contravene this once though due to a combination of weapon geometry and cad issues.
it's partially addressed in asme y14.3-2003 but not specifically for aircraft.

2009-09-05, 05:44 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	ansi 9standards0 code issues - standard drawing views ansi standard drawing views are there any drawing standards that dictate the aircraft orientation in drawing views("top", "front" "left" views)? as for me, a "top view" would always be looking down at the top of the aircraft, with forward to the left. a "front view" would be looking at the left side of the aircraft. a "left view" would be a looking aft from the front of the plane. a "right view" would be looking forward from the aft of the plane. this may be a posting for drafting standards forum: in the uk there was a def stan (5-10 or 05-123 maybe) that defined that the front or nose of the aircraft (or aircraft store) was to the left of the drawings. i had to contravene this once though due to a combination of weapon geometry and cad issues. it's partially addressed in asme y14.3-2003 but not specifically for aircraft. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]