几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子 - ansi 9standards0 code issues

ansi ansi b 16.47 flanges
there are 2 types of flanges available in ansi b 16.47, series a and b. is there any restrictions associated with the use both the series or they can be used anywhere?
check out our whitepaper library.
if you read paragraph 1.2 under the scope in ansi b16.47, it states that series a flanges are for general use and series b flanges are for compact use, because the bolt circle diameter is smaller than series a flanges. these two series of flanges are not interchangeable. use of either a or b series depends on the equipment you are bolting up to in service.
eabrar...
there are several good sources of information about these large piping flanges.
agree with metengr
i have been searching for a dimensional drawing of welded pipe caps and have not found anything yet. we are welding "domed" pipe caps to 4, 6 and 8 inch, schedule 40, 80 and 120 pipe. does anyone have any idea where to find this information?
mike57,
asme b16.9, factory-made wrought buttwelding fittings, table 11 covers these dimensions.
also, just about any fitting chart available from a number of sources including the web.
nozzletwister
houston, texas

2009-09-05, 03:49 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	ansi 9standards0 code issues - ansi b 16.47 flanges ansi ansi b 16.47 flanges there are 2 types of flanges available in ansi b 16.47, series a and b. is there any restrictions associated with the use both the series or they can be used anywhere? check out our whitepaper library. if you read paragraph 1.2 under the scope in ansi b16.47, it states that series a flanges are for general use and series b flanges are for compact use, because the bolt circle diameter is smaller than series a flanges. these two series of flanges are not interchangeable. use of either a or b series depends on the equipment you are bolting up to in service. eabrar... there are several good sources of information about these large piping flanges. agree with metengr i have been searching for a dimensional drawing of welded pipe caps and have not found anything yet. we are welding "domed" pipe caps to 4, 6 and 8 inch, schedule 40, 80 and 120 pipe. does anyone have any idea where to find this information? mike57, asme b16.9, factory-made wrought buttwelding fittings, table 11 covers these dimensions. also, just about any fitting chart available from a number of sources including the web. nozzletwister houston, texas __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]