huangyhg

transition for interference fit???
i have to design a pin such that it fits very tightly inside the roller bearing.
the pin is at the two ends of a pipe , which is being used as a roller.
the i.d. of roller bearing = 7.952"
i randomly used h7p6 and calculated the interference to be between .000 - .003".
should i go for a transition fit for this condition or stick to interference fit???
try posting this on the bearing forum.
what are the specs on the bearing? ball tolerance, internal clearances (abec-?) and such? what are design requirements of the bearing? loads, speed and shaft configuration? my gut tells me that is way too much interference....find someone that has a torrington bearing book they will step you through this process. i have a current design i working on that is a rotordynamic nightmare....90,000 rpm.
best regards,
heckler
sr. mechanical engineer
sw2005 sp 5.0 & pro/e 2001
dell precision 370
p4 3.6 ghz, 1gb ram
xp pro sp2.0
nvidia quadro fx 1400
o
_`\(,_
(_)/ (_)
never argue with an idiot. they'll bring you down to their level and beat you with experience every time.
promoting, selling, recruiting and student posting
are not allowed in the forums.
(add stickiness to your site by linking to this professionally managed technical forum)
title: drafting standards,
description: drafting standards, gd&t & tolerance analysis technical support forum and mutual help system for engineering professionals. selling and recruiting forbidden.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]