几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子 - shaft taper fit

shaft taper fit - tolerance spec or area of contact
looking through various en and iso standards has not helped. if the shaft or hub is blued and fitted together [rotated] a percentage area of the other component is marked.
i am looking for guidance on what would be an acceptable marked area? some publications for machine tool spindles state 80%! is there any basis for this or other values?
the actual taper is for a replacement hub with a 1/10 taper at 190 dia, at the small end, x 280 long and is used to support and fix a "disk" of 4000 kg.
this may be not gettin getting attention because more detail is needed. do you have the specific standards you are referring to? do you have a sample drawing of the situation?
matt lorono
cad engineer/ecn analyst
silicon valley, ca

2009-09-05, 12:52 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	shaft taper fit - tolerance spec or area of contac shaft taper fit - tolerance spec or area of contact looking through various en and iso standards has not helped. if the shaft or hub is blued and fitted together [rotated] a percentage area of the other component is marked. i am looking for guidance on what would be an acceptable marked area? some publications for machine tool spindles state 80%! is there any basis for this or other values? the actual taper is for a replacement hub with a 1/10 taper at 190 dia, at the small end, x 280 long and is used to support and fix a "disk" of 4000 kg. this may be not gettin getting attention because more detail is needed. do you have the specific standards you are referring to? do you have a sample drawing of the situation? matt lorono cad engineer/ecn analyst silicon valley, ca __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]