yang686526

problem with dwg files
problem with dwg files
hello all,
i have a crash reading a set o dwg files, but i cannot attach them to the current post because when i try to upload one of them i receive an error.
probably this is not the right place in order to signal this type of problems, someone have an idea how to solve the problem ?
thanks.
i would go to debug reading with odreadex sample
life would be so much easier if we could just look at the source codefff">fff">
quote:
originally posted by gok
i would go to debug reading with odreadex sample
thank you, my problem is during rendering phase; the library reads the files correctly. i have the same problem with example applications like singledoc and odamfcapp.
at the moment, i want to understand why i cannot upload my files attached to my post in the forum.
maybe the files are too large?
alternative way is to send them by e-mail to support (or to me - that would be a shorter way).
sergey slezkin
quote:
originally posted by sergey slezkin
maybe the files are too large?
alternative way is to send them by e-mail to support (or to me - that would be a shorter way).
the file is small, anyway i sent it to you e-mail address.
thank you!
sergey,
have you perhaps find a solution to my problem ?
thank you
sorry. if you have not received response please resend the file.
btw, did you send it to support or to sslezkin?
sergey slezkin
quote:
originally posted by sergey slezkin
sorry. if you have not received response please resend the file.
btw, did you send it to support or to sslezkin?
i resend the file, now attach machanism seems to work fine.
thank you
attached files (639.1 kb, 5 views)

in 2.3.1 odamfcapp renders the file ok.
there are several invalid objects (you may see them in recover mode), and you will receive an assert in debug configuration, while rendering, due to precision issue, but all that may be ignored.
vladimir
upon further investigation, there happened to be an error in dd, which is revealed when you zoom to extents. we'll look into it.
vladimir