yang686526

odamfcapp doesn't save this dwg to r15 format
odamfcapp doesn't save this dwg to r15 format
how do you do?
i want to develop the down converting program using dwgdirect v1.09.
almost ok.
but the attached drawing stoped my coverting program. (an autocad 2004 sample drawing)
i also have tested it using the sample program (odamfcapp) in dwgdirect v1.09.
then, i have the same result.
what's the problem?
i wait good advice from you.
thanks a lot.
attached files
i failed to reproduce the problem with both initial 1.09 (beginning of october) and 1.09 update (middle of novermber).
i was saving the file to dwg r15. are you sure you have attacheched the right file?
sergey slezkin
yes, it is a right file
yes, it is a right file.
attached file (8th floor plumbing.dwg) is existed in the autocad 2004 samples directory.
autocad 2004 can read this file and write to r15 drawing.
thank to your regards.