yang686526

transition for interference fit???
i have to design a pin such that it fits very tightly inside the roller bearing.
the pin is at the two ends of a pipe , which is being used as a roller.
the i.d. of roller bearing = 7.952"
i randomly used h7p6 and calculated the interference to be between .000 - .003".
should i go for a transition fit for this condition or stick to interference fit???
try posting this on the bearing forum.
what are the specs on the bearing? ball tolerance, internal clearances (abec-?) and such? what are design requirements of the bearing? loads, speed and shaft configuration? my gut tells me that is way too much interference....find someone that has a torrington bearing book they will step you through this process. i have a current design i working on that is a rotordynamic nightmare....90,000 rpm.
best regards,
heckler
sr. mechanical engineer
sw2005 sp 5.0 & pro/e 2001
dell precision 370
p4 3.6 ghz, 1gb ram
xp pro sp2.0
nvidia quadro fx 1400
o
_`\(,_
(_)/ (_)
never argue with an idiot. they'll bring you down to their level and beat you with experience every time.