yang686526

lower case in drawing title/notes
hi guys,
it has been normal practice for me both in the uk and in the us to use upper case/capital lettering on drawings.
however, when you have units of measure is it normal to use the appropriate case. for example meters should be m not m.
i thought it was and was trying to verify it in one of the asme stds but neither my checker or i could find it. the genium manual seems to say to use the appropriate case but if it does state it in the asme i'd like to know.
all text to be upper case, except for units.
i'm not sure either where it is stated. i will look for it.
chris
systems analyst, i.s.
solidworks 06 4.1/pdmworks 06
autocad 06
asme y14.2m-1992 section 4.3
upper case letters shall be used for all lettering on drawings unless lower case letters are required.
"wildfires are dangerous, hard to control, and economically catastrophic."
ben loosli
sr is technologist
l-3 communications
asme y14.5-1994 section 1.5.3.1
"combination si (metric) and u.s. customary linear units. where some inch dimensions are shown on a millimeter-dimensioned drawing, the abbreviation in. shall follow the inch values. where some millimeter dimensions are shown on an inch-dimensioned drawing, the symbol mm shall follow the millimeter values."
david
thanks guys.
ken