【转帖】rotation Scale Of Block Referred To By Mulutileader
 

rotation & scale of block referred to by mulutileader
rotation & scale of block referred to by mulutileader
hi, i'm akira.
i want to get the rotation & scale of block referred to by mulutileader.
(rotation of blockxf(46), scale of blockxf(16)(26))
i used following method.
oddbmleader::blockrotation()
oddbmleader::blockscale()
example)
rotation of block is 30(degrees).
scale of block is 0.5.
but, a value of the rotation is always 0.0,
and a value of the xscale and yscale is always 1.0.
a value of the rotation were about 0.52, and a value of the
xscale and yscale were about 0.5, when i confirmed it in dxf data.
why?
best regards,
akira
this is dwgdiret bug. i entered cr5362 for it.