【转帖】problems with text oblique angle in dd1.12.04
 

problems with text oblique angle in dd1.12.04
problems with text oblique angle in dd1.12.04
hi...i get a problem when saving drawings that contains texts with a high oblique angle.
i've created a test drawing with 3 text with different oblique angle (330, 0, 30) and when i copy this drawing with the sample application odcopyex the result drawing has 3 text with the oblique angles of 0, 0, 30.
the text with the oblique angle of 330 is reset to 0.
thanks
attached files
i failed to reproduce it. which file version are you copying too? dxf/dwg?
are you sure odcopyex is from 1.12.04?
sergey slezkin
well....when you asked i became a bit unsure, but now i've downloaded the files from your site and tried the same dwg with the odcopyex example program and the problem is still there. the text with oblique angle of 330 becomes 0.
regards / malscreen
sorry, i tried odamfcapp not odcopyex.
odcopyex calls audit().
audit checks oblique angle to be in range -85:85 degrees.
330 is valid value (-30 degrees) but audit replaces it with 0.
this will be fixed in next release.
sergey slezkin