【转帖】migration from odt2.0x to dwgdirec
 

migration from odt2.0x to dwgdirect
migration from odt2.0x to dwgdirect
does anybody have expiriences with the migration
from odt2.0 to dwgdirect.
we have 200.000 lines of code to change.
what is the best way ?

hi!..
i just wondered if you had any replies or more information on this now. i am looking at doing the same thing now and i was wondering how its possible.. i posted a help request but i saw noone had replied to yours.. so i wondered if you had heard something?
thanks!
steven

hello!
i probably get the same problem in the near future...
is there some kind of wrapper so we can use our old code to access the wrapper which access dwgdirect?!
kind regards,
dick marjot
arkey systems bv

if you look at the reply to the question i asked below you see that its not possible