【转帖】explode 9polyline0 problem
 

explode (polyline) problem
explode (polyline) problem
hello,
i found a problem in explode functionality of oddb2dpolyline entity.
i am sending you the drawing with two polylines. left is normal polyline, right one is "splined" polyline. if you try to load the drawing into odamfcapp and explode the oddb2dpolyline entity, wrong set of lines will be created.
is this a dd bug?
is it possible to fix it for the next release?
regards, tomaz
attached files
what is wrong with exploded set of lines? some time ago control vertices were not ignored while exploding but it is fixed already.
are you using november (updated) 1.09?
sergey slezkin
hello sergey,
from your description, i can assume, that this is the same problem (control vertices are not ignored while exploding the polyline).
so, it seems, that i do not use the latest version of dwgdirect library. my version is 1.09, but i am not sure if it is november release. i will check it out.
thanks for the answer.
regards, tomaz
hello sergey,
i am using mt (vc2003) libraries, dated on 21.11.2003. and i am experiencing the same problems, as you described in your answer.
regards, tomaz
hello tomaz,
sorry, this bug was fixed on december 1.
sergey slezkin
i'm seeing the same problem as tomaz. is there a known workaround or updated/beta library available reflecting sergey's december 1 fix?
regards,
emilio
next week 1.10 with the fix is to be released
sergey slezkin
super! thanks so much.
regards,
emilio